1989 DODGE DYNASTY 4DR SEDAN
Security
Battery PNK/BLK + (+) IGNITION SWITCH HARNESS
Ignition DK.BLU (+) IGNITION SWITCH HARNESS
Starter01 YEL(+) + (+) IGNITION SWITCH HARNESS
AllDoorTrigger YEL (-) (-) DRIVER'S KICK PANEL
TrunkTrigger TAN/BLK(-) (-) DRIVERS KICK
HoodTrigger N/A
FactoryAlarmDisarm LT.GRN/ORG(-) DRIVERS KICK
ParkingLights BLK/YEL(+) (+) AT LIGHT SWITCH
Remote Start
Battery PNK/BLK + (+) IGNITION SWITCH HARNESS
Ignition DK.BLU (+) IGNITION SWITCH HARNESS
Ignition02 GRN + (+) IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 BLK/ORG + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 YEL(+) + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
KeySense LT.BLU - (-) STEERING COLUMN HARNESS
Tach BLK/GRY (-) (-) AT COIL
SpeedSense WHT/ORG (AC) SENSOR ON TRANSAXLE
ParkingLights BLK/YEL(+) (+) AT LIGHT SWITCH
BrakeLights WHT/TAN (+) AT BRAKE SWITCH
Horn BLK/RED (-) AT HORN RELAY IN FUSEBOX
Doorlocks / Window
PowerUnLock PNK (+) POSITIVE TRIGGER
PowerLock ORG/WHT (+) DRIVER'S KICK PANEL
LeftFrontWindow01 LF:LT.BLU
RightFrontWindow01 RF:BRN/WHT LR:DK.BLU/WHT RR:GRY/BLK
LeftRearWindow01 LF:VIO
RightRearWindow01 RF:VIO/WHT LR:RED/BLK RR:GRN/WH
Convenience
HeadLights LT.GRN (+) AT LIGHT SWITCH
TrunkRelease BLK/WHT(+) (+) RELEASE SWITCH
Mobile Audio / Video
Battery PNK/BLK + (+) IGNITION SWITCH HARNESS
Accessory01 BLK/ORG + (+) IGNITION SWITCH HARNESS
Ground BLK - (-) RADIO HARNESS
Dimmer ORG/WHT (-) RADIO HARNESS
PowerAntenna YEL (+) RADIO HARNESS
FrontLeftSpeakerPos GRN
FrontLeftSpeakerNeg GRN/YEL
FrontRightSpeakerPos VIO
FrontRightSpeakerNeg VIOLET/YELLOW
RearLeftSpeakerPos BRN
RearLeftSpeakerNeg BRN/YEL
RearRightSpeakerPos BLU/RED
RearRightSpeakerNeg BLU/WHT
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
